Only $15.45 with shipping
Original "Peavey" brand cant hook with 4' hardwood handle. Only $77.00 including cont. US shipping.
|
|
|
Ripsaw XL4 Assembly
|
1. INSTALL KNOB INTO CARRIAGE CRANK LEVER AS SHOWN IN PICTURE #2
32. REPLACE 1/4-20 BOLT AND WASHER WITH PLASTIC KNOB AS SHOWN IN PICTURES 1 AND 2.
3. INSTALL "L" SHAPED HANDLE AS SHOWN IN PICTURE #3
4. INSERT SPACER TO ALIGN MOTOR BASE AS SHOWN IN PICTURE #4
5. INSTALL MOTOR BASE AS SHOWN IN PICTURE #4 AND 5
6. INSTALL UPRIGHT HANDLE AS SHOW IN PICTURE #6
7. LAYING SAWMILL FLAT, REMOVE (4) BOLTS AS SHOWN IN PICTURE #7
8. INSTALL (4) SPACERS AS SHOWN IN PICTURE #8. BE SURE TO KEEP LOWER RIGHT SPACER INSIDE BELTS.
9. TIGHTEN SPACERS USING A PAIR OF CHANNEL LOCKS OR PLIERS - PICTURE #8
10. POSITION SAWMILL ONTO CARRIAGE BY ALIGNING SPACERS WITH HOLES IN CARRIAGE.
11. INSTALL FASTENING NUTS AND TIGHTEN SECURELY.
12. INSTALL CLUTCH LEVER PIVOT BRACKET BOLT INTO CARRIAGE FRAME - PICTURE #9
13. INSTALL ENGINE - PICTURE #10 AND 14
14. SECURE ENGINE WITH ENGINE BOLTS
15. INSTALL SECURITY BRACKET - PICTURE #11
16. INSTALL BELTS. (NOTE LOCATION OF PIN MARKED "17" AND BELT POSITION)
17. ADJUST BELT TENSION BY ENGAGING OR MOVING ARM TO THE "UP" POSITION - PICTURE #10
18. ADJUST MOTOR MOUNT LOCATOR SCREW UNTIL BELT IS TIGHT - PICTURE #12
19. TIGHTEN LOCATOR NUTS - PICTURE #12
20. TIGHTEN MOTOR MOUNT NUTS - PICTURE #13
21. INSTALL BELT GUARD - PICTURE #14
22. SERVICE ENGINE AS INSTRUCTED IN ENGINE MANUFACTURER'S MANUAL.
|
1
2
3
4
5
6
7
8
9
10
11
12
13
|
|
